运用点算法反复自动检测齿轮箱齿轮外文文献翻译、中英文翻译.docVIP

XXX 业设计(XX)外文资料翻译 院 系 专　　业 学生姓名 班级学号 外文出处 指导教师评语： 指导教师签名：　　　　　 　　　　　　　　　　　　　　　　　　　　　　 年 月 日 附件2：外文原文 Applied iterative closest point algorithm to automated inspection of gear box tooth Salim Boukebbab, Hichem Bouchenitfa, Hamlaoui Boughouas, Jean Marc Linares Abstract The development of a complete system and quality control of manufactured parts requires the coordination of a set complex processes allowing data acquisition, their dimensional evaluation and their comparison with a reference model. By definition, the parts inspection is the comparison between measurements results and the theoretical surfaces definition in order to check the conformity after manufacturing phase. The automation of this function is currently based on alignment methods of measured points resulting from an acquisition process and these nominal surfaces, in a way that they “fit best”. The distance between nominal surface and measured points(i.e. form defects) calculated after alignment stages are necessary for the correction of the manufacturing parameters(Henke, Summerhays, Baldwin, Cassou, Brown, 1999).In the work, a method for automated control based on association of complex surfaces to a cloud points using the Iterative Closest Point(I.C.P)algorithm for alignment stage is proposed. An industrial application concerning a tooth gear manufactured in our country’s tractor engines is presented. 2007 Elsevier Ltd. All rights reserved. Keywords: CMMs; Complex surfaces; ICP; Gear; Manufacturing process Introduction The design and manufacture of complex surfaces became a current practice in industry. These surfaces can be conceived by a direct method based on the use of Computer Aided Design(CAD)software , or an indirect method which consists in a treatment of a discrete representation of an object model to obtain its CAD model. This last can be obtained throughout an acquisition process, allowing then a much more rapid safeguard, modification, manufacture, automatic inspection,