新型单轨起重机牵引系统液压系统的设计与仿真外文文献翻译、中英文翻译、外文翻译.docVIP

PAGE 41 Design and Simulation for the Hydraulic System of a New-style Monorail Crane Traction System Abstract In order to meet the requirement of the underground cable checked, the hydraulic system of a new-style monorail crane traction system is introduced. The hydraulic system of the traction system was designed. The modeling and simulation for the hydraulic system was build, and the simulation results were analyzed subsequently. The research shows the system performance reaches the requirements. The simulation results are almost the same as the theoretical value, and the design scheme of the hydraulic system is feasible. Keywords: monorail crane, traction system, hydraulic system, modeling and simulation Introduction The design of hydraulic system is the component of the whole system. The hydraulic system is to make the host achieve requirements under the cooperation or control of the hydraulic system. According to the requirement of the new traction system, a hydraulic system was designed; the modeling and simulation for the hydraulic system was build to analysis the hydraulic system performance Calculation of hydraulic system design Analysis of load and movement Calculate work load. Work load is the name for traction 45KN. This is the dynamic friction, fluid power is provided by hydraulic motor。 Calculate inertial load Calculate feeding speed. According to the requirements of the traction system designed, the feeding speed of the system is at 0.12 m/s [2] . Protocol hydraulic system diagram Choose basic hydraulic loop. The design of hydraulic system power is bigger, work load change tiny at work, the system mainly realizes transportation function and lowly demand for stability of system, so volume control loop has been chosen. That is the variable pump-quantitative motor speed regulation The motor oil is mainly as traction wheel operation in the system work, when the system is stable, the hydraulic cylinder piston is in balance, and the flow is unchanged in