WorleyParsons 沃利帕森斯设计指南 KS-PR-DEG-0125 Analysis of Thermal Design of Heat Exchangers Design Guide.pdf

Analysis of Thermal Design of Heat Exchangers Design Guide Document No: KS-PR-DEG-0125 Rev 0 01 December 2019 © Copyright 2019 Worley ACN 096 090 158. No part of this document or the information it contains may be reproduced or transmitted in any form or by any means electronic or mechanical, including photocopying, recording, or by any information storage and retrieval system, without permission in writing from Worley. Table of Contents 1. Introduction 3 2. Scope 3 3. Process 3 3.1 Check HTRI Output Summary - Exchanger performance 4 3.2 Check HTRI Output Summary - Pressure Drop and Velocity 5 3.3 Check HTRI Output Summary - Flow Fractions 6 3.4 Check HTRI Output Summary – Geometry 9 3.5 Check HTRI Vibration Analysis 10 4. Definitions 11 5. References 11 Analysis of Thermal Design of Heat Exchangers Design Guide ii KS-PR-DEG-0125 Rev 0 01 December 2019 1. Introduction This Design Guide provides instructions to the process engineer in analyzing the thermal design output . The intent is not to replace professional judgement or recognized international standards, but to serve as a convenient summary of guideline for proper sizing and selection of a heat exchanger. This Process Design Guide is intended for use as a tool in the organization of Process Engineering. It is not normally issued on a project. 2. Scope The Heat Transfer Engineer (the) or Process Engineer makes the required calculations with latest version of HTRI Exchanger suite. The calculation results are presented to the PE in an Excel document (HTRI Calculation Output) . The HTRI Calculation Output includes at least the following information: ◼ Notes from the HTE ◼ Tube layout sketch ◼ Heat Exchanger sketch with main dimensions ◼ Output summary ◼ Runtime