《增材制造用高熵合金粉》.doc

GB/T XXXX-XXXX GB/T XXXX-XXXX PAGE PAGE IV PAGE PAGE I High-entropy alloy powders for additive manufacturing 增材制造用高熵合金粉 （English translation） （审定稿） Foreword SAC/TC 243 and SAC/TC 562 are in charge of this English translation. In case of any doubt about the contents of the English translation, the Chinese original shall be considered authoritatively. This document is drafted in accordance with the rules given in the GB/T 1.1-2020 Directives for standardization—Part 1: Rules for the structure and drafting of standardizing documents. Attention is drawn to the possibility that some of the elements of this standard may be the subject of patent rights.The issuing body of this document shall not be held responsible for identifying any or all such patent rights. This document was proposed by China Nonferrous Metals Industry Association. This document was prepared by SAC/TC 243 National Technical Committee of Standardization for Nonferrous Metals and SAC/TC 562 National Technical Committee of Standardization for Additive Manufacturing. 增材制造用高熵合金粉 High-entropy alloy powders for additive manufacturing 1 范围Scope 本文件规定了增材制造用高熵合金粉的牌号和分类、技术要求、试验方法、检验规则及标志、包装、运输、贮存、随行文件和订货单内容。 This document specifies the designation, classifications, technical requirements, test methods, inspection rules, marking, packaging, transport, storage, accompanying documents, and the contents of purchase order for high-entropy alloy powders for additive manufacturing. 本文件适用于气体雾化、等离子旋转电极等工艺制备的供增材制造使用的高熵合金粉。 This document applies to high-entropy alloy powders for additive manufacturing prepared by gas atomization, plasma rotating electrodes, etc. 2 规范性引用文件Normative reference 下列文件中的内容通过文中的规范性引用而构成本文件必不可少的条款。其中，注日期的引用文件，仅该日期对应的版本适用于本文件；不注日期的引用文件，其最新版本（包括所有的修改单）适用于本文件。 The following referenced documents are indispensable for the application of this document. For dated references, only the edition corresponding to that date cited applies. For undated references, the latest edition of the referen