02 - Screws, Nuts, Screw Locking.docVIP

Chapter 2 - Screws, nuts, screw locking 1. General information 2. Screws 3. Set screws 4. Nuts 5. Washers 6. Screw locking 7. Thread insert ? 1. General information? Choices for metric ISO- threadsUp to now material numbers were allocated for stainless, acid-resistant or heat-resistant screws, nuts, set screws etc.These parts are only available in the indicated materials in exceptional cases. Until now our purchasing department ordered as follows:A2 (stainless steel) with material numbers: 1.43011.43051.4122 A4 (acid-resistant steel) with material numbers: 1.44011.45411.45711.4713The material 1.481 (heat-resistant steel) is ordered as such.In general you should only use the three qualities mentioned above for standard parts made of stainless steel.If other steels are required you have to check the delivery possibilities with the purchasing department (EK-A).Tightening torques for hexagon screws ISO 4017 (DIN 933) and cylinder head screw with hexagon socket ISO 4762 (DIN 912).The values apply for a general friction number of μges = 0,125? Size of the screws tightening torque MA (Nm)property class ? 8.8. 10.9. 12.9. M 2 0,3 0,4 0,5 M 2,5 0,7 1,0 1,3 M 3 1,2 1,7 2,0 M 4 2,7 3,8 4,6 M 5 5,5 8,0 9,5 M 6 9,5 13 16 M 8 23 32 39 M 10 46 64 77 M 12 80 110 135 M 16 195 275 330 M 20 385 540 650 standard configurationIf the tightening torque is required for assembly (for example clamp-connection), you have to state the torque on the drawing. tightening torque. . . . . Nm tightening torque for cam flange. . . . . Nm ? 2. Screws? 2.1 Hexagon socket head cap screw ISO 4762 (DIN 912) Preferentially: cylinder head screw ISO 4762 - M .. x ..- 8.8 galvanizedstainless steel model A4 There are no requirements concerning the property of the screws. They are definitely noticeably lower than the property of steel screws. Only use for according operation conditions. ? 2.2 Hexagon set screw ISO 4017 (DIN 933) Hexagon se