ppt课件-micehydrogensystem.pptVIP

MICE Hydrogen System Tom Bradshaw Yury Ivanyushenkov Elwyn Baynham Meeting October 2004 – Coseners House Baseline layout Hydride bed Hydride Bed Specification for the Hydride Bed Effectiveness of Buffer Volume Pressure relief valves RD Process Safety Review Process END * * Pressure gauge Non-return valve - P P VP Vacuum pump Bursting disk Pressure relief valve Valve Pressure Coolant Out In Metal Hydride storage unit (20m 3 capacity) Purge valve 0.5 bar 0.9 bar H 2 Detector P P VP1 VP2 Purge valve Chiller /He ater Unit 1 bar P P 0.5 bar 0.9 bar Helium supply Hydrogen supply High level vent Buffer vessel Vent outside flame arrester Extract hood H 2 Detector P P Nitrogen supply P P P P 1 m 3 Hydrogen zone 2 Vent manifold Vent manifold P1 PV1 PV7 PV8 PV2 PV3 PV4 HV1 Fill valve Tbed HV2 HV3 P3 P P2 PV6 High level vent Non return valve 0.1 bar - P P VP Vacuum pump Bursting disk Pressure relief valve Valve Pressure regulator Coolant Out In Absorber window Metal Hydride storage unit (20m 3 capacity) Purge valve 0.5 bar 0.9 bar H 2 Detector H 2 Detector P P VP1 VP2 Purge valve Chiller /He ater Unit 1 bar P P 0.5 bar 0.9 bar Helium supply Hydrogen supply High level vent Buffer vessel Vent outside flame arrester Extract hood H 2 Detector H 2 Detector P P Nitrogen supply P P P P 1 m 3 Hydrogen zone 2 Vent manifold Vent manifold P1 PV1 PV7 PV8 PV2 PV3 PV4 HV1 Fill valve Tbed HV2 HV3 P3 P P2 PV6 High level vent Non return valve 0.1 bar Safety window Checked that there are no safety issues if there is a catastrophic ingress of air. Activation procedure: Pump out absorber Heat to 60-80C Add H2 to about 1.2 bar Leave to soak for 8 hours Tanks need to be horizontal Air ingress reduces capacity and oxidises material – oxidation rate is low. Alloy will become flammable after activation but it needs an ignition source. Black lines absorbtion Dotted lines desorbtion 20l liquid = 16,000 normal litres gas – will absorb this in under 4 hours Hydride Characteri