铁炭法与过氧化氢投加比例[精选].doc

  1. 1、本文档共6页,可阅读全部内容。
  2. 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
  3. 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  4. 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
铁炭法与过氧化氢投加比例[精选]

本帖最后由 cdpulin 于 2010-5-5 17:00 编辑 4 y$ ~5 J9 t2 s2 W ]) {3 ~ : G( F2 ^9 Z$ l% F; @1 F8 v铁炭微电解—Fenton试剂联合氧化深度处理印染废水的研究 4 g$ n) `$ o* G摘要:采用铁碳微电解—Fenton联合氧化技术对印染废水生化处理的出水进行深度处理。通过正交试验考察了pH值、H2O2投加量、铁碳体积比、反应时间对处理效果影响的大小,分别为pH〉铁碳体积比〉H2O2用量〉反应时间。并通过单因素实验确定在最佳反应条件下:pH为2~3,H2O23.2mL/L,铁碳体积比为1:1,反应时间为90min,COD的去除率能够达到90%以上,色度去除率为99%,盐度去除率为64%。各项指标均达到了印染水的回用指标。0 Z+ \6 B7 s4 O a: y2 n4 L 3 l# ]) ^$ N* M/ v. g9 W+ Z- T# ~- ? 关键词:铁碳微电解;Fenton试剂;印染废水;深度处理。 [. ~0 g0 [8 F( S. X B* C c 8 s$ U4 S; ???c) l8 o* Y9 _ M中图分类号:X703.1? ?? ?? ?? ?? ?? ?? ?? ?? ?文献标识码:A 1 y _* N# V+ r2 X G2 l f6 L4 } / N4 H9 ^- D l* h5 NStudy on advanced treatment of printing and dyeing wastewater by joint oxidation technology of iron-carbon micro-electrolysis and? ?? ?? ?? ?? ? ! ^- L$ o1 K7 K/ } r2 U9 \6 l Fenton reagents5 R6 i% s |5 o9 X5 l- y T* u. p0 [. G0 Y- y JIANG Xing-hua1,LIU Yong-jian2,JIN Liang-ji1 g- n m??S4 u1 y8 c 1 m* E } _# i, ]9 j3 A (1. Department of Environmental Science and Engineering,Suzhou??Univ.of Science and Technology. Suzhou 215011 China; Department of Chemical and Biological Engineering,Suzhou??Univ.of Science and Technology. Suzhou 215011 China;). k) `4 k1 I0 H3 u5 y: W$ o 5 L- v, \ P% s L3 q7 b; C Abstract? ?Advanced treatment of printing and dyeing wastewater by joint oxidation technology of iron-carbon micro-electrolysis and Fenton reagents was studied. Orthogonal array experiments was designed to study the different degree of??impact on the treatment effection.The result was pH 〉volume ratio of iron and carbon 〉H2O2 dosage〉reaction time. It is found by single-factor experiments that the best experimental conditions are as follows: pH is 2to 3,H2O2 dosage is 3.2mL/L,volume ratio of iron and carbon is1:1,reaction time 90min.In this condition,the removal rates of COD ,chroma and salinity can reach 91%,99% and64% respectively.Each met the reuse requirements of printing and dyeing water.0 D [! l Q, ?5 i4 j( z. h# ^ # @4 \7 K) X0 m1 { j5 KKey words: iron-carbon micro-electroly

文档评论(0)

dart004 + 关注
实名认证
内容提供者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档