Application of micro-foam drilling fluid technology in Haita area英文文献资料.docVIP

Vol.4, No.7, 438-444 (2012) Natural Science /10.4236/ns.2012.47059 Application of micro-foam drilling fluid technology in Haita area Qingren Sun , Bo Xu 1,2 1,2* 1 2 No. 1 Drilling Company of Daqing Drilling and Exploration Engineering Corporation, Daqing, China Petroleum Engineering Department, Northeast Petroleum University, Daqing, China; Corresponding Author: xubobode@163.com * Received 11 April 2012; revised 15 May 2012; accepted 30 May 2012 ABSTRACT trol overcut rate, which requires the drilling fluids have a good rejection capability and sealing characteristics. Therefore, using the usual drilling equipment is difficult to the successful completion of the drilling in the region. Using common drilling fluid, overbalance pressure is likely to result in the loss and differential sticking. Using pneumatic drilling fluid or underbalanced drilling tech- nology, the preparation of expensive equipment and drilling fluids can not be stabilized inflatable upper part of the normal pressure strata, so the effects can not be ensured. According to a large number of laboratory test results and field trials, it is recommended that the mi- cro-bubble drilling fluids system should be used in the construction process. The micro-foam drilling fluid is a new, reusable, low-cost and low-density drilling fluid; it is a water- based drilling fluid system by the use of surfactants, sta- bilizers, and tackifiers to be supplemented by other treat- ment agent. Compared to the micro-foam drilling fluid with conventional water-based drilling fluid system, it has a low density, low hydrostatic pressure, shielding effect, the filtration rate is small, the ability to bring rock, Lubrication, friction loss, cleanup ability anti-pollution effects, fast drilling speed and therefore it has good leak- proof, oil and gas layer protection and carrying sand, speed and o