钢筋技术交底2（Rebar technology at the bottom 2）.docVIP

钢筋技术交底2（Rebar technology at the bottom 2） I. construction preparation: 1, according to the construction drawings, and the blue prints.the design specification requirements, make the reinforcement, the team in advance put forward all kinds of specifications, level of steel raw material plan, the competent reinforcement date project house bugle call master audit confirmation, project material department organization partial approach. 2. After the entrance of the rebar, the mechanical properties of the samples shall be tested and tested in a timely manner. 3, construction machines and tools preparation: steel breaking machine, bending machine, butt welding machine, welding machine, steel electroslag pressure welding and straight thread mechanical connection set of silk machine installation in place, such as checking mechanical equipment are in good condition. And hang the equipment operating rules at the mechanical equipment. Ii. Rebar straightening and processing: 1, the engineering level Ⅰ reinforced straightening straightening machine. 2. Cutting of steel bar: the cutting machine can cut the steel bar less than 40mm in diameter, and cut it according to the approved reinforcement list. The distance between blade and impact blade can be guaranteed when cutting off. The steel bar with diameter 20mm shall be equal to 1-2mm, and the steel bar with diameter of 20 mm shall be left about 3mm to ensure the lower material length of the steel bar. Ⅰ level of this project reinforced and mechanical connection reinforced with grinding wheel cutting machine cutting, other reinforcing steel cutting machine is adopted to cut off. The bending of steel bar: The cut steel bar is bent according to the single part of the reinforcement bar, the layer, the part and the parts. Ⅰ grade steel using artificial operation wave wrench to steel forming, Ⅰ level reinforced end to 180 ° hook, the arc bending diameter not less than 2.5 times the diameter of the steel and should not be less than the