空资料主板（Null data board）.docVIP

空资料主板（Null data board） Your hardware is complete, but your software hasnt been available yet The type of motherboard you want to determine and what the processor you are using is MTK or ARM architecture, and their methods of writing programs are different. But if you want to have a mobile phone, you cant do it without hardware or software........ As your question is not detailed enough, Ill give you a reference This should include all your problems In order to meet the needs of mass production, the test interface must be considered in mobile phone production test. Common test interfaces include system connectors and RF connectors. System connector is the data interface of mobile phone, mainly used for mobile phones and computer communications, including test command input and online download. Mobile phone during the computer running production test software, control tester and testing computer system through the mobile phone, mobile phone connector, and communication, constantly adjust the various parameters, the performance index meets the requirement of mobile phone. Radio frequency connector is the RF test interface of mobile phone mainboard, and it is the RF test channel of mobile phone and instrument. Due to the size, size and space limitations of mobile phones, micro - Radio connectors are generally used in mobile phones. Some designs combine RF connectors and system connectors. Some design considerations consider cost factors without using RF connectors, and on the motherboard, the antenna access contacts are used as RF test points. For mobile phone testing stations are: FLASH burn, board number write, motherboard test, motherboard calibration, the whole machine function test, the whole machine final test, etc.. Heres a brief introduction to each test session. (1) FLASH burning A normal work mobile phone, in addition to hardware, structure components, but also must have software support. Mobile phone download software is generally posted on the FLASH chip The