数控车技师论文（CNC car technician thesis）.docVIP

数控车技师论文（CNC car technician thesis） NC technician thesis CNC Lathe Training Operation Analysis and fault inspection and analysis method Content abstract: 1 master turning circle, end face, step preparation, skilled use of function instructions. 2 master clamping tools and cutting tool cutting skills. 3 master the thread circulation G92 in FANUC system. 4 master CNC lathe processing parts control size method and chip selection. Key words: NC lathe, FANUC, function instruction, tool selection, programming Figure 1 Tool installation requirements 1 choose 90 degree knife. 2 installed at No. 1 cutter position. 3 when the tool is clamped, the tool point must be strictly aligned with the center of rotation of the workpiece. Too high or too low will cause tool breakage. 4, installation nose extension length of about 1~1.5 times the thickness of the cutter bar. Two workpiece installation requirements 1 the workpiece must be securely mounted. 2 car slot as close as possible to the chuck. 3 if the tank vibration occurs, you can take a one clip a clip method. Three programming requirements 1 proficiency in G00, G01 instruction, verification, cutting tools and applications: G00X_Z_G01X_Z_F_ 2 master auxiliary instruction S, M, T instruction function and application. Format as: M03 S600 T0101 M30 3 familiar with the instruction format of thread processing, tool path and application. Four processing requirements In order to ensure the workpiece size requirements and surface roughness requirements, the workpiece is divided into coarse and fine machining. 1 rough car programming requirements: speed should not be too fast, cutting depth, feed speed, in order to in a short period of time to remove the workpiece margin. Rough car has no strict requirement on cutting surface, so long as it keeps a certain margin of fine vehicle, it needs to be clamped firmly during processing. 2 precision car programming requirements: precision car refers to the end of the turning process, processing can