cambering of four high cold mill with the view of reducing roller ends contact and preventing complex waves四辊式冷轧机的辊型设计的观点减少辊接触,防止复杂波结束.pdfVIP

Engineering, 2011, 3, 359-363 doi:10.4236/eng.2011.34040 Published Online April 2011 (http://www.SciRP.org/journal/eng) Cambering of Four High Cold Mill with the View of Reducing Roller Ends Contact and Preventing Complex Waves 1,2 1 1 1 Zhenhua Bai , Hongxin Si , Xiaodong Shi , Qingtian Zhou 1School of Mechanical Engineering, State Key Laboratory of Metastable Materials Science and Technology, YanShan University, Qinhuangdao, China 2State Key Laboratory of Metastable Materials Science and Technology, YanShan University, Qinhuangdao, China E-mail : bai_zhenhua@, {sihongxin, xiaodong_shi}@126.com Received January 10, 2011; revised March 3, 2011; accepted March 11, 2011 Abstract Based on lots of field experiments and theoretical research, fully thinking the equipment and production craft characters of four high cold mill, a new cambering scheme for four high cold mill is advanced in this paper. This scheme considered the need of production of multi-specification products, as well as the control of roll- er ends contact. The most homogeneous transverse distribution of front tension is the control target and the homogeneous pressure distribution between rollers is the constraint condition. In this technology, working roll curve adapt the combination of cosine curve and high order curve, backup roll adapt the combination of cosine curve, straight line and high order curve. The cosine subentry of working roll and the high order curve subentry are used to control edge wave, the high order curve subentry of working roll is used to control the roll contact, the cosine subentry