验钞机维修文档（Detector maintenance documents）.docVIP

验钞机维修文档（Detector maintenance documents） Fault analysis and treatment of various types of machines; A, self-test class 1, boot times CE1 Reason: (1) fluorescent amplifier circuit is improperly adjusted (voltage test point LM324 fourteenth feet); (2) the circuit board is damp or short circuited; (3) silicon photocell is damaged; Processing: (1) counter clockwise potentiometer W1, the test point voltage is reduced to the required value (0.3 - 0.5V); (2) blow dry or replace the main board with an electric hair dryer; (3) replace the silicon photocell; 2, boot times CE2 Reason: (1) if the main motor is not switched on, the main motor is damaged or the drive circuit is damaged; (2) main transmission belt crack; (3) when the main motor is switched on, the slot type optocoupler is deviated from the encoder or damaged; Processing: (1) check whether there is a foreign body stuck, such as coins, screws (fingers pull the wheel is easy to rotate), replace the power board or the main motor; (2) change the main drive belt; (3) positive or replaced groove type optocoupler; 3, boot times CE3 or CE4 Reason: (1) dust or damage of counter tubes; (2) the lead plug is loose; (3) counting, transmitting and receiving tube shifting; Treatment: (1) cleaning dust, with a multimeter counting launch terminal 1 pin and the 3 pin voltage is 1.10~1.12V does not match for the launch tube damage, counting 2 feet and 4 feet receiving terminal voltage are 0.15~0.20V inconsistent for receiving tube damage; (2) re welding leads or replacement inserts; (3) the position of the transmitting and receiving tubes is counted and counted neatly; 4, boot times CE5 Reasons: (1) dust, foreign objects block or damage to the banknote sensor; (2) the position offset of the banknote sensor; Processing: (1) cleaning dust, removing foreign objects or replacing sensors; (2) the position of the regular banknote sensor and the banknote holder; 5, boot times CE6 The reason: (1) large head signal output line or open; (2) bad