王峰《嵌入式系统原理与应用教学》第5章 定时器 编程.pptVIP

∵只有TI1FP1和TI2FP2连到了从模式控制器， P148 图6.3 ∵只有TI1FP1和TI2FP2连到了从模式控制器，∴PWM输入模式：只能使用TIMx_CH1/TIMx_CH2信号。 P148 图6.3 void TIM_PWMIConfig(TIM_TypeDef* TIMx, TIM_ICInitTypeDef* TIM_ICInitStruct) { uint16_t icoppositepolarity = TIM_ICPolarity_Rising; uint16_t icoppositeselection = TIM_ICSelection_DirectTI; /* Check the parameters */ assert_param(IS_TIM_123458_PERIPH(TIMx)); /* Select the Opposite Input Polarity */ if (TIM_ICInitStruct-TIM_ICPolarity == TIM_ICPolarity_Rising) { icoppositepolarity = TIM_ICPolarity_Falling; } else { icoppositepolarity = TIM_ICPolarity_Rising; } /* Select the Opposite Input */ if (TIM_ICInitStruct-TIM_ICSelection == TIM_ICSelection_DirectTI) { icoppositeselection = TIM_ICSelection_IndirectTI; } else { icoppositeselection = TIM_ICSelection_DirectTI; } if (TIM_ICInitStruct-TIM_Channel == TIM_Channel_1) { /* TI1 Configuration */ TI1_Config(TIMx, TIM_ICInitStruct-TIM_ICPolarity, TIM_ICInitStruct-TIM_ICSelection, TIM_ICInitStruct-TIM_ICFilter); /* Set the Input Capture Prescaler value */ TIM_SetIC1Prescaler(TIMx, TIM_ICInitStruct-TIM_ICPrescaler); /* TI2 Configuration */ TI2_Config(TIMx, icoppositepolarity, icoppositeselection, TIM_ICInitStruct-TIM_ICFilter); /* Set the Input Capture Prescaler value */ TIM_SetIC2Prescaler(TIMx, TIM_ICInitStruct-TIM_ICPrescaler); } else { /* TI2 Configuration */ TI2_Config(TIMx, TIM_ICInitStruct-TIM_ICPolarity, TIM_ICInitStruct-TIM_ICSelection, TIM_ICInitStruct-TIM_ICFilter); /* Set the Input Capture Prescaler value */ TIM_SetIC2Prescaler(TIMx, TIM_ICInitStruct-TIM_ICPrescaler); /* TI1 Configuration */ TI1_Config(TIMx, icoppositepolarity, icoppositeselection, TIM_ICInitStruct-TIM_ICFilter); /* Set the Input Capture Prescaler value */ TIM_SetIC1Prescaler(TIMx, TIM_ICInitStruct-TIM_ICPrescaler); } } ● 两个ICx信号被映射至同一个TIx输入。 ● 这2个ICx信号为边沿有效，但是极性相反。 ● 其中一个TIxFPy信号被作为触发