定位轴线存在偏差外传力钢框架节点传力板参数分析.docVIP

定位轴线存在偏差外传力钢框架节点传力板参数分析 　　作者简介：徐忠根（1965），男，浙江金华人，研究员，工学博士，Email：xuzhonggen@263.net。 　　摘要：利用大型通用有限元软件ANSYS建立不考虑初始缺陷的外传力钢框架节点分析模型，并与试验结果进行对比以验证模型的正确性。对钢柱定位轴线偏差满足和超出规范允许值2倍的外传力钢框架节点进行分析，在偏差达到规范限制的条件下，对6组钢梁翼缘宽度、厚度不同的试件进行分析，并相应调整传力板的宽度、厚度等参数，进行荷载位移曲线以及应力分布分析。结果表明：传力板宽度和厚度为外传力钢框架节点的关键设计参数；所加设的传力板厚度宜与钢梁翼缘厚度相同，宽度宜为0.75～1.25倍钢梁翼缘宽度。 　　关键词：钢框架；定位轴线；初始缺陷；节点；传力板；有限元分析 　　中图分类号：TU391文献标志码：A 　　Parameter Analysis of Forcetransforming Plates in Outside Steel 　　Frame Joints with Location Axis DeviationsXU Zhonggen1， LIANG Guangxian1， DENG Changgen2 　　（1. School of Civil Engineering， Guangzhou University， Guangzhou 510006， Guangdong， China； 　　2. Department of Structural Engineering， Tongji University， Shanghai 200092， China）Abstract： By large general finite element software ANSYS， an analysis model of outside steel frame joints without considering initial defect was built. Correctness of simulation was proved by comparing the results of experiments. The steel frame joints with location axis deviations which were justified to the code and two times as that of the code were analyzed. Six groups of specimens with different widths and thicknesses of steel beam flanges and different widths and thicknesses of forcetransforming plates， whose location axis deviations were limits of design code， were calculated. Analysis of loaddisplacement curves and stress distribution were carried out. The results show that the width and thickness of forcetransforming plate are taken as the key design parameters for outside steel frame joint with forcetransforming plate. The thickness of adding forcetransforming plates should be as same as that of beam flanges， the width of adding forcetransforming plates should be 0.751.25 times as that of steel beam flanges. 　　Key words： steel frame； location axis； initial defect； joint； forcetransforming plate； finite element analysis 　　0引言 　　自北岭6.6级地震和阪神7.2级地震[12]之后，各国学者致力研究提高钢框架节点抗震性能的方法，所提出的改进型连接方式大致可分为加强型[3]、削弱型[4]以及加强削弱混合型[5]。徐忠根等[6]提出一种外传力钢框架节点连接方式。在实际施