低屈服点钢板剪力墙力学性能分析-结构工程专业论文.docx

西安建筑科技大学硕士学位论文 西安建筑科技大学硕士学位论文 西安建筑科技大学硕士 西安建筑科技大学硕士学位论文 Research on Mechanical Performance of Low Yield Point Steel Shear Walls* Major: Structural Engineering Name: Huang Yuqi Instructor: Prof. Hao Jiping ABSTRACT In recent years, the mechanical performance of steel plate shear wall is studied by many domestic and foreign scholars. But most of the infill plates adopt the ordinary steel; little research of low yield point steel plate shear wall whose infill plate is made of low yield point steel has been carried. Based on theoretical analysis of the mechanical properties, the low yield point steel plate shear wall is simulated by ANSYS to investigate the elastic and elastic-plastic buckling behavior of infill plate and the lateral stiffness, shear bearing capacity and hysteretic behavior of the steel shear wall. In addition, effect of infill plate on the stability of the frame column is studied in this paper. The above research of low yield point steel plate shear wall could provide the theory and design criteria in the practical application. Research contents and corresponding results in this study are listed as follows: First the shear buckling stress analysis of the low yield point steel plate shear wall has been carried. The obtained results show that buckling stress calculation method in the current technical specification for high rise steel structure (JGJ 99-98) cannot be directly applicable in the low yield point steel plate shear wall. The suggestions of calculation method of its shear buckling stress are therefore proposed. Under the same horizontal load, the thickness and buckling stress of infill plate of low yield point steel plate shear wall would be greater than ordinary steel plate shear wall when the identical frame are used. The infill plate depends more on pure shear resistance to lateral before buckling in low yield steel plate shear wall. As lateral stiffness of infill plate before buckling is about 28.2% greater than which after buckling. There