静态路由rip路由协议的配置.docVIP

实验六静态路由、rip路由协议的配置 实验目的： 认识静态路由、缺省路由、rip路由 配置基本路由环境 实验设备： 港湾路由器、华为路由器各两台 实验内容： 静态路由和缺省路由的配置： pci、pc2与路由器相连的线是什么网线：交叉线缆 上聞看出 pc 1 的 ga t eway 是｛| ?么： RouterA 上图看出p c 2的g a t e \va y是什么： RouterB (D使用静态路由完成上图网络环境的配置 用验证命令显示各个路由器上的路由表，分别说明静态路条目是什么？ 直连网络： 10. 1. 1.0 20. 1. 1.0 通过静态路由配置的网络：30. 1. 1.0经由20. 1. 1. Iserial端口 POping 30.1.1.2 Pinging 30.1.1.2 with 32 bytes of data: Reply from 10.1.1.1: Destination host unreachable? Reply from 10.1.1.1: Destination host unreachable. Reply from 10.1.1.1: Destination host unreachable? Reply from 10.1.1.1: Destination host unreachable. Ping 3tati3tic3 for 30.1.1.2: Packets: Sent = 4, Received = 0, Lost = 4 (100% loss)r Pinging 30.1.1.2 with 32 bytes of data: Reply from 30.1.1.2: bytes=32 time=12ma TTL=126 Reply from 30.1.1.2: byte3=32 time=15m3 TTL=126 Reply from 30.1.1.2: bytes=32 time=llma TTL=126 Reply from 30.1.1.2: byte3=32 time=13m3 TTL=126 Ping statistics for 30.1.1.2: Packets: Sent = 4, Received = 4, Lost =0 (0% loss) Approximate round trip times in milli-seconda: Routerl［叫回Physical ConfigCLI Routerl ［叫回 Physical Config CLI IOS Command Line Interface RB(config-if) # %LINEPR0T0-5-UPD0WN: Line protocol on Interface Serial2/0r changed state zo up RB(config-if)黎exit RB(config)零interface Serial2/0 RB(config-if) RB# M - mobile, B - M - mobile, B - BGP ? OSPF inter area Codes: C - connected, S - static, I — IGRP, R - SIP, D — -IGRP, ZX — SIGRP external, 0 — OSPF, IA N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 SI - OSPF external type 1, S2 - OSPF external type 2, S - SGP i - IS-IS, LI - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODS P - periodic downloaded static route Gateway of last resort is not set 20.0.0.0/24 is subnetted, 1 subnets C 20.1.1.0 is directly connected, Serial2/0 30.0.0.0/24 is subnetted, 1 subnets C 30.1.1.0 is directly connected, FastSthernet0/0 SB# CopyPasteIOS Command Line Interface Copy Paste IOS Command Line Interfac