- 13
- 0
- 约6.19千字
- 约 10页
- 2018-12-15 发布于广东
- 举报
风积沙干压实路基回弹模量与含水量、压实度关系的研究.doc
风积沙干压实路基回弹模量与含水量、压实度关系的研究
风积沙干压实路基回弹模量与压实度、含水量的关系研究
贾聿卿 李志农 陈杰
(新疆农业大学乌鲁木齐830000;新疆交通厅乌鲁木齐830000;
新疆交通科学研究院乌鲁木齐830000)
,风积沙作为沙漠环境下的路基填料有其特殊性。在一般路基土
回弹模量与压实度、含水量的研究中表明,回弹模量与二者有密切的关系,
与含水量尤为相关,相关系数的绝对值达到0.8以上。但是在风积沙回弹
模量与压实度、含水量试验屮,笔者发现回弹模量与含水量的相关系数很
低,相关显著性也很低,对这一特殊现象,展开分析,研宄在干压实施工
下风积沙路基压实度、含水量对回弹模量的影响。
关键字:风积沙、回弹模量、压实度、含水量、相关度
Study on Relation Between Modulus of Resilience of Aaeolian Sand Dry
Pressing Roadbed and Puddlability amp; Moisture Content
Jia Yuqing Li Zhinong Chen Jie
(Xinjiang Agricultural University Urumqi 830000 Communications
Department of Xinjiang Uygur Autonomous Region Urumqi 830000
Xinjiang Communications Research Institute Urumqi 830000)
Abstract: As roadbed filler, aeolian sand has its particularity in desert
environment. It is indicated in the general reseach of the relation between modulus of resilience of roadbed soil and puddlability amp; moisture content that the modulus of resilience has a close relation with the two, particularly the moisture content, even the absolute value of related
coefficient reaches more than 0.8%. However, in the test of modulus of
resilience of aeolian sand and puddlability amp; moisture content, the
author discovered that the related coefficient between modulus of resilience
and moisture content is quite low, also the significance of correlation
coefficient. For this special performance, analysis was launched to study how
the puddlability amp; moisture content of aeolian sand roadbed influence on
modulus of resilience under dry pressing.
Key words: Aeolian Sand, Modulus of esilience, puddlability, moisture
content,
relevancy
0引言
风积沙作为一种路基填料形式已经被认可,它主要用于沙漠及沙漠周
边地区公路路基垫层的修筑,对于沙漠区修筑的公路而言,采用风积沙作
为路基填料符合就地取材,由弊变利,经济实用等要求。
风积沙路基的回弹模量是风积沙最为重要的路用性能参数之一,是路
基路面结构设计中表征材料强度特性的指标,影响风积沙路基回弹模量的
因素很多,如不同沙漠中风积沙的物质特征、密度、含水量、试验时承载
板直径等。本文主要对影响一般路基回弹模量较大的含水量和压实度这两
个因素的进行研究,判断在风积沙这种特殊路基填料中,含水量、压实度
对风积沙路基回弹模景是否有显著的影响。
由于风积沙级配差,用常规方法不易压实,但当风积沙在干燥状态和
接近饱和状态下易达到最大密实度,这对于在沙漠腹地干旱缺水的环境屮
施工非常重要,因此,国内的风积沙路基施工均采用干压实施工。本文即
研究在干压实状态下,回弹模量与含水量
您可能关注的文档
最近下载
- 2026-2030中国无机富锌底漆行业市场发展趋势与前景展望战略分析研究报告.docx
- 宇电AI-500_501 型智能化测量报警仪表 S068-11 500-501(8.3中文说明书.pdf VIP
- 2025年仁爱版九年级上册期末英语复习测试 看图写话专题训练 .pdf VIP
- 煤矿生产安全事故应急救援预案.doc VIP
- 2024年山东畜牧兽医职业学院单招语文考试模拟试题及答案解析.docx VIP
- 切开缝合结扎止血.pptx VIP
- 2022二级建造师《机电》章节练习5.26.docx VIP
- 混凝土质量缺陷修补施工方案.doc VIP
- 2020年幼小衔接行业白皮书.pptx
- 《第三军医大学学报》简介和投稿指南(官方认证).doc VIP
原创力文档

文档评论(0)