苍翼默示录连续变幻拓展版诺爱尔实用连段二.docVIP

苍翼默示录连续变幻拓展版诺爱尔实用连段二 5A 6A (6C ? The most basic empty even ,,and , 6C, , ,5A 6A , 6C JD 6B 6C , , , and , and , and ,,and , 6C, , , In the most basic version, hJD is more stable, but in reverse 214A 2B , , BBC , BBC , 236c , , , , , , , , , , , , , , , 6C, , , , , , , , , , , , , , 0, and The most basic part of the starting point, part 2, 22B and 236A will be turned upside down. The section should be omitted from the 22B part? 6 c 22 b slightly delay Air-dropped 2B 6C 236c 6C 6C Air-dropped 2B 6C 236c 6C 6C ,,,,,,,, ,,,,,,,, 6C , , , , , , , , , , , , , , the airdropsThere is no difficulty in starting the base of the airdrops Air-dropped 2B 6C 22BBBC dc6C 236A hJD hJD , , , , , , , , , , , , , , , , , , ,,,,,,,bb Drop in 22B, the damage is higher than the above, note the partial reference ground to the initial link? It is recommended to use 4D (2D / 5D) 6A 6C 2D 5D 236D (3052) D start the migrant worker connect, simple and practical All kinds of D .. JB 623 d JB J236C Another migrant worker, simple and practical GC 6A , hJB JC (1) 2B , , , , , , , , , , , , , , , , , , , ,,,,,,,,,,,,,,,,,,,, Eliminating the 6B can be a lot more stable? JC notes that its lhit. After de, you should use the microdash6c (the dc6C below is considered to be de microdash6c)? In fact, the de post dash6C should be developed from cs2? There are also GC 6A , , ,〉??? The method of bringing in (coimnonly used), and the carrying time 236A, or the various pairs of empty touching to 5B / 5C / 6C hJA ... Note: rats don，t work (JB/JC ? 5A 6C , , , , ,,,,,bb6A,, 6C JD ,,,,,,,,623D 6C 236A Air-to-ground or,,, (JB/JC ? 5A 6C , , , , ,,,,, bb 6A , , 6C JD ,,,, ,,,, 623D 6C 236A Air-to-ground or , , , , ,, ,, , , , , ,,,, ,,,, 6A is available to the air. 6C 236A is slightly delayed,of them are not. slightly delayed, of them are not. otherwise a 6C would be too high for 22B? Some Part of the body will save the last 6B And the low space J236C CI I 6C