个人电子技术经验积累.docxVIP

个人电子技术经验积累 1: what is the positive bias of the diode? The positive voltage is added to the P section, while the N section plus the negative voltage? Positive bias? The positive bias is that the diffusion current increases greatly, while the reverse bias increases the drift current? However, the drift current is formed by the movement of minority carriers, so there is reverse saturation current! 2: general low frequency signal, the thickness of the resista nee line is in order to flow how much current, and the thickness of the resistance, regardless of the size of the copper wire itself is very small resistance, of course, exceptional circumstances exception! The 3:mos tube is a carrier that relies on a carrier of multiple electrons. It is not the same as the daughter and the daughter of the transistor? The utility model is a self isolating device, and the isolation island in the crystal triode is not needed to save the heart slice area and is suitable for the ultra large scale circuit? It is characterized by voltage control! That is, the control terminal requires little current and is easy to integrate? 4: how to judge the CBE pole of the triode? And how to determine the GDS of the MOS tube? A directly check data, B with Multimeter diode file, P connection is positive, n negative when there is a digital display, so there are a few measurements, you can know whether PNP or NPN, B end which can be concluded? Then measure the magnification with the HEF meter of the meter? If you answer it correctly, you can judge the result? The MOS tube is normally connected to the heat sink by the D? OK, the D is simple? Add a power to the GS, or you can use the multimeter diode to look at the GS, and then to DS, there，s a digital display. And if the short circuit DS There is no number to go. You can confirm gs. 6: DC feedback is used to stabilize the quiescent operating point, and AC feedback is used to improve the performance of the amplifier? 7: capacitance and resistance of seri