流体错误解决.docVIP

个人流体模拟错误分析 本人刚刚接触ansys半年，对学习期间出现的一些能够解决的错误总结如下，与大家共享。其中可能会有不足的地方，请大家批评指正。Coefficient matrix has a negative diagonal.??Probably indicates divergent solution.? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ? VX Node= 194. 系数矩阵的对角线是负数，可能导致解发散。发散时首先检查加载是否完全。需要约束的对象没有约束，就会出现发散的情况。Nominal fluid density must be positive.??A value of -1 indicates the default value was not changed.??A positive value of this property must be input. ??Nominal Density = -1.解决方法：Main Menu Solution FLOTRAN Set Up Fluid Properties，将density项选为AIR-INNominal fluid viscosity must be positive.??A value of -1 indicates the default value was not changed.??A positive value of this property must be input. Nominal Viscosity = -1.解决方法：Main Menu Solution FLOTRAN Set Up Fluid Properties，将viscosity项选为AIR-IN*** WARNING *** The degree of freedom solution is not available. The PLVECT command is ignored. 自由度不可用，此命令被忽略。Main Menu General Postproc Read Results Last set*** ERROR *** Maximum number of conjugate gradient iterations exceeded three times. The run is terminated. DOF solved was PRES.??共轭梯度的最大值的迭代数超过三次。进程终止。这条语句是求解时出现的。在指定的求解器清扫数内共轭梯度求解器不满足收敛条件。模型可能需要更大的清扫数。解决方法：FLDATA19,TDMA,PRES,100*** ERROR ***? ?Error attempting to back up unuseable results file.??Check READ/WRITE permission. T_post_01.rfo.? ? 在偿试回到结果文件时出错。检查读写许可。jobname.rfo在求解时出现。通常rfo文件很大，不知是不是因为出错的原因。可以将它删除，好像不影响程序运行。运行正常的文件是没有rfo文件的。*** ERROR ***? ?? ?? ?? ?? ?? ?? ?? ?? ?CP =? ???119.000? ?TIME= 15:24:54Volume mesh failure - perhaps due to:? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?? ?????(1) Poorly shaped triangle facets: Mesh surfaces with tris, modify mesh control to get good tri mesh, then VMESH again.? ?? ?? ?? ?? ?? ?????(2) Complex geometry: Subdivide volume and try again. 体网格划分错误，可能是由于：1，错误的三角面形状：用三角形划分表面，修改网格控制以得到好的三角网格，然后再次划分。2，复杂几何体：把体分成小无块，再试一下。*** WARNING ***? ?? ?? ?? ?? ?? ?? ?? ? CP =? ???119.578? ?TIME= 15:25:04Mid-nodes of some elements have been modified to lie on straight edges because of distortion wi