材料与试验协会 B103， B103M-98ｅ2磷青铜板、薄板、.PDFVIP

Designation: B 103/B 103M – 982 Standard Specification for Phosphor Bronze Plate, Sheet, Strip, and Rolled Bar1 This standard is issued under the fixed designation B 103/B 103M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1 NOTE—Table 2 was editorially corrected in October 1999. 2 NOTE—Table 2 was editorially corrected in February 2003. 1. Scope * 2. Referenced Documents 1.1 This specification establishes copper-tin alloy (phosphor 2.1 ASTM Standards: bronze), copper-tin-lead alloy (leaded phosphor bronze), and B 248 Specification for General Requirements for Wrought copper-tin-lead-zinc alloy (bearing bronze), plate, sheet, strip, Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled and rolled bar. The phosphor bronzes commonly are used for Bar3 deep drawing into bellows and stamping and forming into B 248M Specification for General Requirements for spring devices and into terminals and connectors for electrical Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and apparatus because they combine high strength with high Rolled Bar [Metric]3 elongation. The leaded phosphor bronzes are used where B 601