基于51单片机的LED摇摇棒设计.docx

本科毕业设计说明书（论文）目录 第 Ⅰ 页 共 Ⅰ 页 毕业设计说明书（论文）中文摘要 为了适应现代人们对于精神追求的更多要求，本文设计了一套可用于对LED摇摇棒设计的方案，该方案通过LED灯组成阵列实现显示界面。本套设计方案采用51单片机作为系统的主控芯片，搭配LED组成的线阵以及其它外围I/O设备，通过方案论证，最终确定了本文的设计方案。 在对设计出的硬件进行系统测试时，通过按键来对模式进行切换，本文设计的摇摇棒具有4种模式，显示的内容分别为：欢迎使用、LOVE、爱心图案和兔子耳朵图案。经过系统测试，按键调节至每个模式时，通过左右摇晃摇摇棒均可实现与设计对应的图案，因此，本文设计的基于单片机的摇摇棒符合设计要求。在符合要求的基础上后续仍可对模式图案进行增加。由于本文设计的模式只能通过按键逐次切换，因此后期可以进行设计实现直接选择相应的图案进行选择。 关键词 单片机 LED线阵 摇摇棒 模式切换 毕业设计说明书（论文）外文摘要 Title Design of Intelligent Curtain Based on MCU Abstract In order to meet the more requirements of modern people for spiritual pursuit, this paper designs a set of solutions that can be used for the design of LED rocking sticks. The solution uses LED lights to form an array to realize the display interface. This design scheme uses 51 single-chip microcomputer as the main control chip of the system, with a linear array composed of LEDs and other peripheral I/O devices. Through the demonstration of the scheme, the design scheme of this article is finally determined. In the system test of the designed hardware, the mode is switched by pressing the button. The rocker designed in this article has 4 modes, and the displayed contents are: Welcome, LOVE, Love pattern and Bunny ear pattern. After the system test, when the keys are adjusted to each mode, the pattern corresponding to the design can be realized by shaking the rocker from left to right. Therefore, the rocker based on the single-chip microcomputer designed in this article meets the design requirements. On the basis of meeting the requirements, the pattern patterns can still be added later. Since the mode designed in this article can only be switched one by one by pressing the button, the design can be implemented later and the corresponding pattern can be directly selected for selection. Keywords MCU LED linear array rocking stick mode switching 目 录 TOC \o 1-3 \h \z \