课程三与实验一、CISCO路由器操作与配置CiscoIOS.pptVIP

Slide 1 of 1 Purpose: This slide describe the IP address global configuration command on the Cat 1900 switch. Emphasize: Why does a layer 2 switch requires an IP address? It is used for switch management purpose. Like to telnet to the switch, or to use the Web based Visual Switch Manager to manage the switch. Note: On the Cat 1900 and 2900xl switches, the IP address is always in VLAN1. It can not be moved to any other VLAN like the Cat 5000 SC0 port. Slide 1 of 1 Purpose: This slide describe a high level overview of the startup sequences on the router. Emphasize: There is a detailed flowchart that covers this in much more details in Chapter 6. Config register is also covered in Chapter 6. The startup routines for Cisco IOS software have the goal of starting router operations. The router must deliver reliable performance connecting the user networks it was configured to serve. To do this, the startup routines must: Make sure that the router comes up with tested hardware. Find and load the Cisco IOS software that the router uses for its operating system. Find and apply the configuration statements about router-specific attributes, protocol functions, and interface addresses. The router will make sure that it comes up with tested hardware. When a Cisco router powers up, it performs a power-up self-test (POST). These diagnostics verify the basic operation of the CPU, memory, and interface circuitry.After verifying the hardware functions, the router proceeds with software initialization. Some startup routines act as fallback operations that are able to perform the router startup should other routines be unable to do so. This flexibility allows Cisco IOS software to start up in a variety of initial situations. Slide 1 of 1 Purpose: This slide describe the difference of the console output of an unconfigured router versus a configured router. Emphasize: Router has setup mode to prompt user for an initial configuration. The Cat 1900 switch has no setup mode, it comes with