WorleyParsons 沃利帕森斯设计指南 KS-PR-DEG-0132 Process Analyzers Design Guide.pdf

Process Analyzers Design Guide Document No: KS-PR-DEG-0132 Rev 0 01 December 2019 © Copyright 2019 Worley ACN 096 090 158. No part of this document or the information it contains may be reproduced or transmitted in any form or by any means electronic or mechanical, including photocopying, recording, or by any information storage and retrieval system, without permission in writ ing from Worley. Table of Contents 1. Introduction 3 2. Scope 3 3. Purpose 3 4. Process Engineer’s Responsibilities 3 5. Reference Material 4 6. Definitions 5 7. References 8 Process Analyzers Design Guide ii KS-PR-DEG-0132 Rev 0 01 December 2019 1. Introduction This Process Design Guide is intended for use as a tool in the organization of Process Engineering. It is not normally issued on a project, however documents based on it, such as process datasheets, may be issued. 2. Scope This document covers general guidelines to assist the process engineer in preparing the specification for Process Analyzer Systems. This document is to be used as a guide only, as optimal analyzer design is influenced by a variety of factors unique to the situation. Preparing the specifications for Process Analyzer Systems is a multi-discipline effort for which the analyzer specialist, usually a member of the Instrumentation Group, is ultimately responsible. It should be noted that this document contains valuable guidance but is not comprehensive. 3. Purpose The function of process analyzers is to measure and transmit information about the chemical composition, physical properties, or chemical properties of a sample. The need for process analyzers is driven by:  Economic considerations – process control/monitoring and process improvements  Environmental considerations – government mandates compliance  Safety