保温杯盖注塑模具设计说明书.docVIP

淮安信息职业技术学院毕业设计论文 PAGE PAGE I 摘 要 本次设计主要是针对塑料保温杯盖的模具设计。该模具设计分为制件的分析，注塑设备的选择，凸凹模的设计和计算，浇注系统的设计，导向机构的设计，推出结构的设计和模架的选择等；在此次设计中运用UG和CAD对塑件进行分析和模具设计，主要包括动定模、浇口、流道、冷料穴、定位圈的设计；完成标准模架、导向机构、脱模机构、排气系统及冷却系统的设计，完成动定模底座、动定模板、推杆、推杆固定板、浇口导套以及支撑板零件的设计，然后对整个数据，参数进行校核，不合理需要进一步修改，利用Auto CAD完成部分零件图及装配图的设计。最后整理撰写说明书 关键词 ：型腔；点浇口；注塑机。 PAGE PAGE II PAGE PAGE I Abstract This design is mainly aimed at the mold design of plastic water cups. The mold design is divided into the analysis of parts, the selection of the injection molding equipment, the design and calculation of the convex and concave die, the design of the gating system, the design of the guiding mechanism, the design of the structure and the selection of the mold frame, and so on. In this design, the UG and CAD are used to analyze the plastic parts and the mold design, including the dynamic mold, the gate, the runner, the flow path, and the design of the mold. Design of cold material point and positioning ring, complete the design of standard mold frame, guiding mechanism, demoulding mechanism, exhaust system and cooling system, complete the design of moving fixed mould base, dynamic template, push rod, push rod fixed plate, gate guide sleeve and support plate parts, and check the whole data and parameters, unreasonable need to enter. One step modification, using Auto CAD to complete part of the part drawing and assembly drawing design. Finalising the graduation thesis Key words: cavity; point gate; injection molding machine. PAGE PAGE IV PAGE PAGE I 目 录 TOC \o 1-3 \h \u 6420 第一章 绪论 1 624 第二章 设计说明 3 3439 2.1塑件分析 3 1644 2.1.1 成型塑料件的工艺性分析 3 16377 2.1.2 成型塑件的材料分析 4 3707 2.2 注塑设备的选择 6 14186 2.2.1估算塑件体积 6 11627 2.2.2 注塑机的选择 6 11885 2.3成型零件尺寸的计算 7 8714 2.4分型面的选择 10 17463 2.5 浇注系统的设计 10 976 2.5.1 浇口套的选用 10 15128 2.5.2分流道的布置 11 14778 2.5.3浇口设计 12 31829 2.6导向机构的设计 13 13617 2.6.1导柱的设计 13 5128 2.6.2 导套的设计 13 30960 2.7脱模结构的设计 14 11490 2.8 排气系统和冷却系统的设计 15 29760 2.8.1排气系