S-1201-CE(NEWLY ENGAGED ENGINE CADET).docVIP

Ship: Rank: Date: Name: Embark at / on: Disembark at / on: Chief Engineer’s comment: No. Item Level Preparation for Arrival / Departure 1 Ability to record bunker data (F.O., L.O.) PREPARE:1,.rag、diesel oil 、sounding gauge、paste for sounding DO、pencil paper。 2.check how much oil remaining in engine log book and check about out how much the ullage and sounding level with sounding book., get the recent trim from deck department. SOUNDING:(FO)Let the sounding gauge down till the level is near the value checked out and move the sounding gauge slowly feeling it touching the oil. If the weather is not good ,it is better to sounding several times and get the average reading for record. Confirming the cover and spring in the normal position. (DO)Let make some paste onto the gauge near the oil level the sounding gauge down to touch the bottom .read the value on the gauge and record .put spring and cover back to normal position . Read the volume from settling and service tank. CALCULATING: check the sounding table with the represent trim and calculate the volume(V).calculate out the MT with real temperature (MT equal to V multiply volume rectify factor and weight rectify factor and density at 25 degree centigrade.) .Record the data . 2 Ability to control the Main Engine Cooling Oil Supply 1.always keep the sump tank oil level in the normal value about 70cm. 2.if the level goes down should add lube oil till normal position. 3.if ambient temperature is very low ,always keep lube oil purifier running for heating and purifying lube oil . 4.always keep lube oil pump running to keep stable pressure. 3 Ability to start and operate auxiliary machinery in parallel and set to automatic mode START: 1.clear the ambient of generator. 2.make sure .lubricating oil pressure at the normal value . 3.make sure the staring air can be direct use . 4.Manually turn the flywheel to make sure shaft is in good condition with indicator cock open. 5.close the indicator cock . 6.Change