DIHART铰刀介绍.ppt

KOMET GROUP GmbH – KOMET DIHART AG Specialized lecture - standard devices DAH? 50HS - Adjustable adaptor Tool shank diameter can up to ? 20mm 刀杆最大夹持直径达? 20mm Hydraulic clamping screw 液压锁紧螺钉 Adusting module 调整模块: 1 Adjusting ring 调整环 4 Adjusting screw 调整螺钉 Adaptor 刀柄:SK 40; HSK63; BT 40 Constructional structure 安装结构 KOMET GROUP GmbH – KOMET DIHART AG Specialized lecture - standard devices DAH? 50HS - Adjustable adaptor 4 Adjuting screw Adjusting ring using micrometer, center the indicator if possible on the gauge. 使用千分表，如果可能的情况下，尽量在磨制的基准上进行测量。 Running tool follow machining direction by hand,find the high point. 用手沿刀具的加工转向旋转刀具，找出最高点。 Bring the adjusting screw on the high point by Rotate the adjusting ring. 转动调整环，使一个调整螺钉在最高点位置。 Correct half of the runout error by ajusting screw, afterward continue ajusting 5 μm more. 通过调整螺钉使刀具往反方向移动跳动误差的一半，然后再多移动5 μm Push back the tool at the center line by opposite adjusting screw. 对面螺钉再往回顶，使刀具回到中心位置。 Also adjuting other 2 screws like before. 同样调整另外2个螺钉。 In the end, adjusting the 4 screw set the tool runout error 2 μm. 最终通过调整4个螺钉使刀具跳动小于2 μm Assemble 安装 KOMET GROUP GmbH – KOMET DIHART AG Specialized lecture - standard devices Dihart Floating holder DPS Low cost 低成本 Long tool life 长寿命 Continuous machining results 加工质量稳定 Slim design 纤细结构设计 No wearing parts 无易损部件 Perfect reaming on lathe 在车床上高质量铰孔 ! Characteristics 特点 KOMET GROUP GmbH – KOMET DIHART AG Specialized lecture - standard devices DPS Modular Structure Reliable function, also using the same cutting speeds and feed rate as normal. 结构可靠，可使用如常规加工般的切削速度和进给 Radial and angle compensation are constructional ensured by preset 径向和角度补偿是通过预先设置的间隙来保证 Maximum angle compensation 30‘ 最大角度补偿30‘ Radial clearance 0.08mm (not adjustable) 径向间隙0.08mm(不可调) Compact design, central coolant supply 结构紧凑，中心内冷供给 模块化结构 KOMET GROUP GmbH – KOMET DIHART AG Specialized lecture - standard devices D