课题换热器毕业设计翻译.docVIP

Comparison of Water-water Heat Exchanger Between Shell-and-tube Type and Plate Type Abstract : The closed-cycle cooling water system in the water of heat exchanger selection, discusses in detail the shell and tube heat exchanger with plate structure and properties of technical and economic comparison of selection for the water of heat exchangers provide a reference. Keywords: heat exchanger performance comparison Power plants have been built from the domestic point of view, for the closed cycle cooling water system of the water of heat exchanger there are two types, one is shell and tube heat exchanger, and the other is a plate heat exchanger. Shell and tube heat exchanger is commonly used in heat exchangers form, in power plant design has been widely used, but some imported units in the domestic power plant, gas-steam combined cycle power plants and nuclear power plants have adopted multi-plate heat exchanger . As the plate heat exchanger compact, light weight, high heat transfer efficiency, a growing interest in it. In this paper, shell and tube and plate heat exchanger to compare two kinds of patterns and make selection of reference. A shell-and plate heat exchanger structure Introduction (1) Shell and tube heat exchanger Shell and tube heat exchanger is a former Marine Room, tubes, tube, after the composition of the water room. Tubes used to pump-type tubes, which consists of front and rear tube plate, baffle plate, rod, will be away from the tube, heat-exchange component. Rod and tube plate, split-flow plate using threaded connections, heat exchange tube and tube sheet welding using sealed expansion joint increases. In the shell side of the water at the entrance to the tube bundle to set anti-scour plate, in order to prevent the cooling water directly to scour Tube. Bundle into or out of order to reduce friction when the tube in the bundle with the slide. In order to check the clean room, trash, sediment and tube blockage in the water chamber before a