TM01模介质腔体滤波器的设计-微电子学与固体电子学专业论文.docxVIP

华中科技大学硕士学位论文 华 中 科 技 大 学 硕 士 学 位 论 文 II II Abstract The rapid development in information technology today, along with the fifth information technology revolution development of wireless communication technology, wireless communication technology have entered rapid development period.The communication frequency spectrum is more finer, communication is more and more higher, the requirements for microwave filters are also getting higher and higher, at the same time, mobile communication and portable terminal miniaturization, lightweight, high reliability of direction, has also put forward higher requirements on microwave dielectric ceramic materials based on microwave devic.Therefore, in the 3G mobile communication base station, miniaturization, high Q value, high stability of the dielectric cavity filter becomes a hotspot at present. We designed and made a working at WCDMA frequency band is used in 3G mobile communication base station above the six pole cross coupling dielectric cavity filter using the dielectric resonator and filter theory in this paper,the dielectric resonator filter’s working mode is TM01 mode.Through theoretical calculation and simulation combining, we give the six pole cross coupling dielectric cavity filter specific size, and processing production, actually measured properties: 2.22GHz center frequency, bandwidth of 80MHz, pass band insertion loss is less than 0.5dB, out-of-band rejection than 80dB dielectric resonator filter, the measured performance to satisfy our needs index, and it can be used in industrial production. Based on the production of six pole cross coupling dielectric cavity filter, we designed a four pole of tunable dielectric resonator filter by using the high frequency simulation software Ansoft HFSS 12 in this paper.The structure of the tunable dielectric resonator filter is novel, the center frequency is 5GHz, and the mode of separation characteristics between eigenmodes and parasitic mode are good. We creative using of the