反转螺旋薄壁管件液压胀形仿真及其优化-机械制造与自动化专业论文.docx

HYPERLINK \l _bookmark7 6.3.2 隐式回弹计算仿真 65 HYPERLINK \l _bookmark8 6.4 利用 LS-DYNA 对反转螺旋薄壁管件进行回弹仿真的模拟 67 HYPERLINK \l _bookmark9 6.4.1 反转螺旋薄壁管件回弹仿真模型 67 HYPERLINK \l _bookmark10 6.4.2 反转螺旋薄壁管件回弹分析 67 HYPERLINK \l _bookmark11 6.5 本章小节 69 HYPERLINK \l _bookmark12 总结与展望 70 HYPERLINK \l _bookmark13 参考文献 72 HYPERLINK \l _bookmark14 攻读硕士学位期间完成的论文 77 HYPERLINK \l _bookmark15 致谢 78 Contencts Abstract in Chinese I Abstract in EnglishIII HYPERLINK \l _bookmark0 Contencts IX HYPERLINK \l _bookmark1 Character1 Introduction 1 Foreword 1 The research background and meaning 1 Research situation of Hydroforming inside and outside of China 3 Research situation of Hydroforming outside of China 3 Research situation of Hydroforming inside of China 4 The problems and prospects of Hydroforming 4 Reversal spiral thin-wall tube 5 The origin of Reversal spiral thin-wall tube 5 Problems and solutions of Reversal spiral thin-wall tube 6 The research objective and research content of this paper 6 Main contents of this chapter 7 HYPERLINK \l _bookmark2 Chapter 2 The forming technology of Reversal spiral thin-wall tube 8 Forming process introduction of Hydroforming 8 Theory and steps of Hydroforming 8 Merit and demerit of Hydroforming 9 Numerical simulation theory foundation of Hydroforming 10 Plastic deformation characteristics and the influence factors 10 Material elastic-plastic behavior description 10 Main contents of this chapter 13 HYPERLINK \l _bookmark3 Chapter 3 Hydroforming process simulation and optimization design method 14 The choice of optimization design method about Hydroforming of thin wall tube 14 Introduction of optimization method 14 Characteristic of optimization algorithm 15 Hydroforming process parameters optimization design model of thin wall tube 15 The establishment of the optimization model 15 3.2.2. Hydroforming process parameters optimization design flow chart of thin wall tube 15 3.2.3 Optimization calculation steps 16 Hydroforming