风力发电机组变流器IGBT桥的设计、控制策略的仿真和分析-水利水电工程专业论文.docxVIP

II II Abstract The world’s total wind power installed capacity keep on growing all those years, and the capacity of single wind turbine goes higher and higher at the same time, due to fast development, researches have to improve the efficiency and stability of wind power generation in order to meet the requirements of the power system and intensify the competitiveness of wind power. In this article, a general simulation model of a 1.5MW is developed with the help of Matlab/Simulink for a typical 1.5MW variable-speed constant-frequency (VSCF) wind power conversion system based on doubly-fed induction generator power conversion system based on doubly-fed induction generator (DFIG). It shows a preliminary study of MW level wind power generation system in software simulation environment. With the mathematical model of wind turbine, coordinate transformation, the control system, DFIG and the structure of converter. The simulation models are built. Space vector pulse width modulation (SVPWM) has been used for both grid-side converter (GSC) and machine-side converter (MSC). Use proper control parameters to make the designed simulation model run very well. Then build a simulation model for the three-level converter and use the proper control strategy to run the whole system. The simulation results show that when connected with ideal power grid with using grid voltage oriented vector control, the GSC controller can maintain the DC voltage to support the normal operation of DFIG converter; and the MSC controller can realize the maximum power point tracking and reactive power control of DFIG under rated wind speed with the implement of stator flux oriented vector control. The active power control need tens of seconds because of the long inertia time constant of wind turbine and DFIG rotor. The simulation model of three-level converter shows the total harmonic distortion with the each line current is much lower. Keywords: GSC;MSC;simulation;DFIG;three-level; PAGE PAGE IV 目