端板型半刚性钢混凝土组合节点的试验研究结构工程专业论文.docxVIP

南京工业大学硕士学位论文节点肛矿曲线性能关系用于半刚性钢一混凝土组合框架受力性能的分析。 南京工业大学硕士学位论文 节点肛矿曲线性能关系用于半刚性钢一混凝土组合框架受力性能的分析。 关键词， 钢棍凝土组合结构 半刚性节点 受弯承载力初始转动冈B度极限转动能力 南京工业大学硕士学位论文ABSTRACT 南京工业大学硕士学位论文 ABSTRACT The study on the behavior of semi—rigid joints in steel—concrete composite frames gets widely attention recently A high degree of continuity can be achieved at a very low cost just providing the slab with rebar running along the column．Furthermore，stiffness and ultimate resistance carl be controlled in a rather simple way by a suitable selection ofsteel connection detailing and amount of reinforeement．But at present，the knowledge ofjoint behavior’and of its influence on frame behavior，is not broad enough to allow for joint design and detailing at the required degree of reliability．Thus it is necessary to study moment resistance，rotation stiffness and rotation capacityofthejoints． In this paper,six specimens on end-plate composite beam-to-column joints and two specimens on end-plate composite beam-to-column joints weDo designed to subject to static load．The factors of M-庐characteristics about semi—rigid composite joints，including bolts， profiled steel sheeting,beam，column,stiffen rib and reinforcement，ale studied．111e test ■ results show that the semi-rigid composite joints have higher moment resistance and rotation stiffness than steel joints，and composite joints have powerful rotation and dissipation energy capability． Based on the test results，the forrnulas for moment resistance of semi-rigid end-plate composite joints arc presented．Which adopt plastic analysis method，and take for reinforcement damage as failure criterion．The accuracy of the proposed method have been verified by the test results． The concept of adding the contribution of rebar to a bare steel connection is utilized to form the stiffness of composite semi—rigid joints under hogging moment．Upon this basis，the calculating formulas of initial rotation stiffness are presented．The calculated results show to be jn good agreement with