切削刃的几何形状，工件的硬度的影响，进给速度和切削速度对表面粗糙度和力量完成硬化AISI H13钢的车削外文文献翻译、中英文翻译.docVIP

PAGE EFFECTS OF CUTTING EDGE GEOMETRY,WORKPIECE HARDNESS, FEED RATE AND CUTTING SPEED ON SURFACE ROUGHNESS AND FORCES IN FINISH TURNING OF HARDENED AISI H13 STEEL Tugrul ?zel, Tsu-Kong Hsu, Erol Zeren Department of Industrial and Systems Engineering Rutgers, The State University of New Jersey, New Jersey 08854 USA Abstract In this study, effects of cutting edge geometry, workpiece hardness, feed rate and cutting speed on surface roughness and resultant forces in the finish hard turning of AISI H13 steel were experimentally investigated. Cubic boron nitrite inserts with two distinct edge preparations and through-hardened AISI H-13 steel bars were used. Four factor (hardness, edge geometry, feed rate and cutting speed)- two level fractional experiments were conducted and statistical analysis of variance was performed. During hard turning experiments, three components of tool forces and roughness of the machined surface were measured. This study shows that the effects of workpiece hardness, cutting edge geometry, feed rate and cutting speed on surface roughness are statistically significant. The effects of two-factor interactions of the edge geometry and the workpiece hardness, the edge geometry and the feed rate, and the cutting speed and feed rate are also appeared to be important. Especially, small edge radius and lower workpiece surface hardness resulted in better surface roughness. Cutting edge geometry, workpiece hardness and cutting speed are found to be affecting force components. The lower workpiece surface hardness and small edge radius resulted in lower tangential and radial forces. 1. INTRODUCTION Hard turning, machining ferrous metal parts that are hardened usually between 45-70 HRC, can be performed dry using polycrystalline cubic boron nitride (PCBN, commonly CBN) cutting tools as extensively reported in literature [1-8]. Research results in the literature concerning mechanism of serrated chip formation i