力—位移分控方式下曲面参数对帆面回弹规律的影响-influence of surface parameters on the springback law of sail surface in force-displacement control mode.docxVIP

AbstractProcess of multi-point forming has been widely applied to social production becasue of its strong flexibility. Since the force-displacement seperated control can effectively inhibit indentation and wrinkling defects, springback control has become a major area of research in multi-point forming at present.In this paper, springback law of sail surface with double curvature is studied. First of all, results from theoretical derivation prove t hat the force-displacement seperated control has significant advantages in springback inhibition compared with conventional multi-point forming. Then characteristics of sail surface with double curvature are analyzed. In this thesis, ANSYS is adopted as the numerical simulation platform and x, y sides of sail surface are adopted as research objects. Segmented curvature fitting is adopted to obtain the impact of radius of curvature, thickness, sail parameter on springback law. The results show that for springback phenomenon of sail surface with double curvature, the two directions will influence each other, while the direction with bigger radius of curvature hold s dominant position. On the direction with bigger radius of curvature, the springback increases with increasing radius of curvature, decreasing sheet thickness, and increasing sail parameter. On the direction with smaller radius of curvature, the springback increases with increasing radius of curvature, and increasing sheet thickness. Rate of decrease for springback lines continue to accelerate with increasing sail parameter.Sail Surface is tridimensional curved surface in space. It relies on the height adjustment of the punch elements to achieve its shape. So it would be effective to guide practice if springback law is linked with height adjustment of punchelements.uzobjstands for the amount change in the Z direction of punchelements’ corresponding location on the sheet.uz x ,uz y stand for