UNITANK工艺生物脱氮除磷性能中试研究-市政工程专业论文.docxVIP

华 中 华 中 科 技 大 学 毕 业 设 计 论 文 II II Abstract At present, water pollution situation is still grim in China, with the increasing pollution emission reduction requirements, the sewage treatment process enhanced biological nitrogen and phosphorus removal from municipal wastewater treatment will become a research hotspot. With the advantage of saving area, flexible control and simple management, UNITANK process has been be gradually extended, but there are also some defects, for example, biological phosphorus removal is not ideal. The paper studied on the effect and affecting factors (inclined-tube, stirring intensity and anaerobic time) of UNITANK process, taking the typical Guangdong urban sewage as the research object. The pilot-study of UNITANK process shows that the average removal rates of UNITANK process on COD, SS, TP, TN and NH3-H are 89.02%, 94.27%, 84.39%, 45.19%, 97.64%. And the effluent quality has met B standards of the highest level in Discharge Standard of Pollutants for Municipal Wastewater Treatment Plant (GB18918-2002). The full-scale test shows that the removal rates of TN and TP of A/A/O process are 3.98% and 19.62% higher than UNITANK process, while the UNITANK process savings about 894250 degrees power consumption , 912.5 tons polyacrylamide, and 105000 yuan maintenance costs every year. After the study on affecting factors of UNITANK process, it shows that additional inclined tubes on UNITANK’s side pool have little influence on the removal of COD, TP and NH3-H, while improving by 15.82% at the removal rate of TN. The stirring intensity has a great influence on biological nitrogen and phosphorus removal. When stirring intensity increased from 5 r / min to 10 r / min, the removal rate of TP and NH3-H are separately improved by24.18% and 14.60% while TN dropped by 1.28%. An appropriate extension of anaerobic time will improve the nitrogen and phosphorus removal, while too long will lead to degradation of sedimentation performance and treatment effect.