婴儿监视器测试计划英文版.docVIP

婴儿监视器测试计划英文版 Product code PRODUCT TEST PLAN Product Name: Date: 29/03/2004 Page 1 OF 5 Revision: 01 Art No.: The purpose of this test plan is the generation and definition of safety, quality, durability, functional performance, and reliability requirements for this product, as well as providing a system for testing and evaluation to determine compliance with these requirements. This test plan, along with the test methods and procedures herein referenced, is intended to specify all relevant test requirements for this product based on applicable prevailing federal regulations, voluntary customers standards, Saitek Marketing requirements, and Saitek Quality standards. The test plan will be reviewed periodically, and revised as needed to reflect changes in applicable federal regulations, voluntary standards, design, test procedures, and marketing requirements. Product code PRODUCT TEST PLAN Product Name: Date: 29/03/2004 Page 2 OF 5 Revision: 01 Art No.: Product code PRODUCT TEST PLAN Product Name: Date: 29/03/2004 Page 3 OF 5 Revision: 01 Art No.: 3.5 High Temperature Leave Test Leave the product for 48 hours in a constant temperature bath whose temperature is set as 60 degree plus minus 2. After that, Leave it for 2 hours or longer at normal temperature, then check it to confirm there is no abnormality in appearance, structure and operations. 4.Functional Test Unless otherwise specified, the products shall be tested in ambient temperature 23 ± 2 centigrade and relative humidity 20%-70%.Listed below are detail requirements for this product. Mechanical performance. Abrasion Resistance of Paint Use a rubber eraser to rub the paint surface under test 10 times over a length of 25mm When so doing, apply a force of about 500gf to the eraser with the fingers Wet Rubbing Dampen a piece of shirting No.3 with water Rub a wet piece of shirting over; give the silk print of surface under test 10 times over a length of 30mm. When so doing, apply a force of about 500gf with the finge