水塔智能水位控制系统设计.zip.docVIP

华北理工大学轻工学院毕业论文（设计） PAGE PAGE I 华北理工大学轻工学院 毕业论文设计 设计题目: 水塔智能水位控制系统设计 所属学院： 电气信息学院 专 业： 自动化 专业班级： 2014q自动化2班 姓 名： 张思 学 号： 201424470212 指导教师： 申童 摘 要 水塔水位的控制系统是我国供水系统较为常用的，水塔供水的主要问题是塔内水位应该始终保持在一定的范围内，避免“空塔”、“溢塔”现象发生。传统的控制方式存在控制精度低、能耗大的缺点，而智能控制系统的成本低，安装方便，灵敏性好，是节约水源，方便生活的水塔水位控制的理想装置。 本论文使用PLC可编程控制器作为一个小水塔水位自动控制系统的核心，涉及到需要分析水塔水位功能的自动控制系统。主要方法是通过水塔中的液位传感器来检测实际的水位，并通过PLC的CPU的智能扩展模块将得到的信息通过模拟量的转换传送给变频器，以控制水泵电动机的操作。完成整个系统的自动供水过程。如果水位低于或高于设定值时，危险警告信号将被发出。本论文给出设计的基础上很好地执行PLC塔液位控制系统的具体过程。并使用组态王软件画出水塔自动供水的动态流程。 关键字 水塔水位控制系统，PLC，液位传感器， Abstract Water tower’s water level control system is relatively commonly used in the Chinese water supply system; the main problem of the water tower’s water supply is the water level in the water tower should always remain within a certain range, to avoid the “empty tower”, “overflow” tower phenomenon. Traditional control mode exist the shortcoming of control precision low, energy consumption big, and the cost of intelligent control system is low, easy installation, and good sensitivity, it is the ideal device to save water, to facilitate the life of the water tower’s water level control. In this paper, using PLC programmable controller as the core of a small water tower water level automatic control system, involving the need to analyze water tower features automatic control system. The main method is through the tower level sensor to detect the actual water level, and through the PLC CPU intelligent expansion module will transmit the information obtained by the conversion to analog converter to control the pump motor operation. To complete the entire process automatic water supply system. If the water level is lower or higher than the set value, the hazard warning signal will be issued. This paper gives specific processes perform well PLC tower level control system on the basis of design. Configuration software to draw and use automatic water tower dynamic processes. Keywords: tower water level control system , PLC, configur