胶印机着墨过程影响因素分析.pdfVIP

第41卷 第6期 北 京 工 业 大 学 学 报 Vol.41 No.6 2015年 6月 JOURNAL OF BEIJING UNIVERSITY OFTECHNOLOGY Jun. 2015 胶印机着墨过程影响因素分析 初红艳,张笑林,蔡力钢 (北京工业大学 机械工程与应用电子技术学院,北京 100124) 摘 要:胶印机输墨系统的油墨通过着墨部分传递到承印物上,所以着墨部分性能的好坏对印品的质量有重要的 影响. 运用有限元模拟软件Ansys Workbench对着墨过程进行模拟仿真,研究当印版网点面积率为100%时,着墨 辊与印版间的压力和印刷速度对着墨过程的影响. 通过分析可以得出:随着着墨辊和印版间压力的增加,着墨辊 1、2 的着墨率有增加的趋势,而着墨辊3、4 的着墨率则有减小的趋势;随着印刷速度的增加,着墨辊 1的着墨率有 逐渐变小的趋势,而着墨辊2、3、4 的着墨率有逐渐变大的趋势. 关键词:胶印机;着墨辊;流固耦合;着墨率 中图分类号:TS801.9 文献标志码:A 文章编号:0254-0037(2015)06-0816-07 doi:10.11936/ bjutxb2014060055 Analysis of Factors Influencing Inking Process of Offset Printing Machine CHU Hong-yan,ZHANG Xiao-lin,CAI Li-gang (College of Mechanical Engineering and ElectronicsTechnology,Beijing University of Technology,Beijing 100124,China) Abstract:The performance of inking part of an offset printing machine has an important impact on the quality of printing product because its function is to transfer ink onto the substrate. In this paper,the finite element simulation software Ansys Workbench is used to simulate the inking process, and the influence of the pressure between the inking roller and the plate and the printing speed on the inking process is analyzed when the dot percentage is 100%. Results show that the inking ratio of the first two inking rollers has an increasing trend,however,the inking ratio of the other two inking rollers has an oppositetrendalongwithincreasingpressurebetweentheinkingrollerandtheplate. Withtheincreaseof the printing velocity,the inking ratio of the first inking rollers has a decreasing trend and inking ratio of the other three inking rollers has an opposite trend. Key words:offset printing machine;inking roller;fluid-structure