finite element modeling of stress strain curve and micro stress and micro strain distributions of titanium alloys— a review有限元模型的应力应变曲线和微观应力和微观应变分布的钛合金,审查.pdfVIP

Journal of Minerals and Materials Characterization and Engineering, 2012, 11, 953-960 Published Online October 2012 (http://www.SciRP.org/journal/jmmce) Finite Element Modeling of Stress Strain Curve and Micro Stress and Micro Strain Distributions of Titanium Alloys— A Review Gangi Setti Srinivasu, Narasimha Rao Raja Department Mechanical Engineering, National Institute of Technology, Warangal, India Email: nivassetti@, rnraonitw@ Received July 15, 2012; revised August 20, 2012; accepted August 29, 2012 ABSTRACT Most of the alloys like titanium, steel, brass, copper, etc., are used in engineering applications like automobile, aero- space, marine etc., consist of two or more phases. If a material consists of two or more phases or components it is very difficult to predict the properties like mechanical and other properties based on simple laws such as rule of mixtures. Titanium alloys are capable of producing different microstructures when it subjected to heat treatments, so much of money and time are squandering to study the effect of microstructure on mechanical properties of titanium alloys. This squandering can be reduced with the help of modeling and optimization techniques. There are many modeling tech- niques like Finite element method, Mat lab, Mathematical modeling etc. are available. But Finite element method is widely used for prediction because of capable of producing distributions of stresses and strains at any different loads. From the literature it is observed that there is a good agreement between the calculated and measured stress strain curves. This review paper describes the effect of volume fraction and grain size of alpha phase on the stress strain curve of the titanium