西门子培训-840D-sl-SW45SP2-02en.ppt

* * * * * The following wizards are still missing in SINUMERIK Operate 4.5 SP1 1) Supplement for the measuring functions regarding axis couplings and file functions 2) Parameterizing dialog (Wizard) for the current and speed setpoint filter (in the context of the measuring functions). ? SW 4.6 3) Function generator ? SW 4.6 4) Inputs/outputs dialog under Drive system drive devices ? SW 4.6 5) Interconnections dialog under Drive system Drive devices/Infeed/Drives ? SW 4.6 6) Starting the drive commissioning Wizard with the MDS involved from the data set Wizard ? SW 4.6 7) Drive-axis assignment ? SW 4.6 8) Porting the HMI-Advanced dialog Commissioning Safety Integrated Create SI data Adapt SI encoder to SINUMERIK Operate 9) Porting the HMI-Advanced dialog Commissioning Safety Integrated Create SI data Adapt SI SBR to SINUMERIK Operate 14) NC+DRV input/output, status display (X122, X123) ? SW 4.6 15) Interconnection dialogs (BICO in the drive) ? SW 4.6 16) New data set Wizard 2^n motors ? SW 4.6 17) Create magazine configuration DB ? open 18) ATW Acceptance Test Wizard ?dbSI integrated in SINUMERIK Operate ? open * * * * * * No notes * No notes * No notes * No notes * No notes * No notes * * * * No notes * * No notes * * * * * * * * * * * * * * * * * * * * * * Notiz:Collision AvoidanceTo avoid collisions in the machining area of the machine tool, SINUMERIK SW 4.5 SP2 provides the Collision Avoidance option (6FC5800-0AS02-0YB0). Based on 3D models of collision bodies, monitoring is performed for a machine/machine collision and a machine / tool cutting edge collision, directly dependent on the axis positions. Collision Avoidance is available in all operating modes and can be commissioned directly via SINUMERIK Operate. An offline commissioning tool is planned for autumn 2013. In addition to the Collision Avoidance option, the Simultaneous recording and 3D simulation software options and a NCU730.3 hardware are required for the display on SI