超仿棉聚酯水刺医卫非织造材料的研究及性能-纺织工程专业论文.docxVIP

东华大学硕士学位论文AB 东华大学硕士学位论文 ABSTRACT PAGE PAGE III RESEARCH ON THE TECHNOLOGY AND PERFORMANCE OF COTTON-LIKE PET SPUNLACE MEDICAL AND HEALTH NONWOVEN MATERIAL ABSTRACT Sanitary napkins, diapers and pads surface layers are typically based on hot-air-through nonwovens, calendaring-bonded nonwovens, thin spun-bonded nonwovens, etc. while hot air-through nonwovens are most popularly used among all of them, because of its fluffy, high permeable and skin-friendly properties. In addition, spunlace nonwoven material, has been widely used in the hygienic area around the world. This study combines hot air-through technology and spunlace technology, carding cotton-like PET and some certain proportional ES fiber together to form web with spunlace method, then drying it with hot temperature. The final product has high added value, short liquid strike-through time and low cover stock wetback. We studied the cotton-like PET spunlace nonwoven material in order to find the substitution of surface material of sanitary napkins, diapers,etc.It was introduced that the cotton-like PET fiber had good properties and cotton-like appearance and handing which could substitute or partly substitute the cotton fiber, thus relieving the short supply of cotton in China. The cotton-like PET fiber we had was tested with nylon 66 group in it. The nylon 66 group has made the cotton-like PET with longer break elongation, higher hydrophilic property and moisture regain than normal PET fiber. This paper studied the relationship of fabric density, thickness,tensile strength of cotton-like PET/ES nonwoven material. The study shows, the thickness, tensile strength and air permeability of the material increase with the increase of rate of ES fiber. Fabric density is proportional to thickness and tensile strength, inversely proportional to the air permeability. Its tensile strength increased and then decreased with the increase of spunlace energy. When the fabric density of the material was larger than 50 g/m2